Snap Frames

Available Sizes

A0          841 x 1188 mm

A1          594 x 841 mm

A2          420 x 594 mm

A3          297 x 420 mm

A4          210 x 297 mm

A5          148 x 210 mm

Lay the poster frame face-up. Secondly open all 4 sides. This is best done by spacing hands equally along one side with thumbs on the outside edge. The fingers can now lift the frame until ‘pops’ open. Remove the cover sheet.

These snap frames are supplied predrilled for screw fixing. They can be fixed to any smooth surface.

Locate screw holes. These are located on the inside of the frame. These can be used for marking the fixing positions.

With slightly uneven surfaces such as brick, be careful not to overtighten the screws. Overtightening the screws can distort the frame.

The frame is now securely fixed in position. It is now ready to accept a poster. 1st step is to open all four sides of the frame. Next slide the poster into position. Fit the cover sheet. Snap the frame shut on all sides to hold the poster!

WHERE ARE CLIP FRAMES USED?

Snap frames are used on many different situations worldwide. Our national distribution shows the same popularity in Australia. The Artesian Clip Frames are one of the most popular poster display systems Australia wide.

Applications:

Retail Stores, Multi Location Branding Events, Directional Signage, Library Information, Showroom Signage, Safety Messages, Promotional Signs, Exhibition and Event Exhibits, Office and Team Messages.

What Are Snap Frames Made From?

The outer frame is made from aluminium, the backboard is normally made from polypropylene sheet and the cover is made from matt PVC sheet.